kio_floppy - en to wa translation catalogue (10 entries)

en: Could not access drive %1.
    The drive is still busy.
    Wait until it is inactive and then try again.
wa: Dji n' a savou avu accès å lijheu %1.
    Li lijheu est co ocupé.
    Ratindoz ki soeye nén actif, adon sayîz co on côp.

en: Could not write to file %1.
    The disk in drive %2 is probably full.
wa: Dji n' a savou scrire li fitchî %1.
    Motoit kel diskete e lijheu %2 est rimpleye.

en: Could not access %1.
    There is probably no disk in the drive %2
wa: Dji n' a savou avu accès a %1.
    Motoit k' i gn a pont d' diskete e lijheu %2.

en: Could not access %1.
    There is probably no disk in the drive %2 or you do not have enough permissions to access the drive.
wa: Dji n' a savou avu accès a %1.
    Motoit k' i gn a pont d' diskete e lijheu %2 oudonbén k' vos n' avoz nén d' droets assez po avu accès al diskete.

en: Could not access %1.
    The drive %2 is not supported.
wa: Dji n' a savou avu accès a %1.
    Li diskete %2 n' est nén sopoirtêye.

en: Could not access %1.
    Make sure the floppy in drive %2 is a DOS-formatted floppy disk 
    and that the permissions of the device file (e.g. /dev/fd0) are set correctly (e.g. rwxrwxrwx).
wa: Dji n' a savou avu accès a %1.
    Soeyoz seur kel diskete e lijheu %2 est ene diskete abwenêye e cogne DOS
    eyet k' les droets do fitchî d' l' endjin (/dev/fd0) sont definis comifåt (rwxrwxrwx).

en: Could not access %1.
    The disk in drive %2 is probably not a DOS-formatted floppy disk.
wa: Dji n' a savou avu accès a %1.
    Motoit kel diskete e lijheu %2 est ene diskete nén abwesnêye e cogne DOS.

en: Access denied.
    Could not write to %1.
    The disk in drive %2 is probably write-protected.
wa: Accès nén permetou.
    Dji n' a savou scrire so %1.
    Motoit kel diskete %2 est waerantî sconte li scrijhaedje.

en: Could not read boot sector for %1.
    There is probably not any disk in drive %2.
wa: Dji n' a savou lére li secteur d' enondaedje di %1.
    Motoit ki gn a nole dikete e lijheu %2.

en: Could not start program "%1".
    Ensure that the mtools package is installed correctly on your system.
wa: Dji n' a savou enondé l' programe « %1 ».
    Soeyoz seur kel pacaedje mtools est astalé comifåt so vosse sistinme.
